Platinum Kit Build Guide

1. Each pole is labeled with with an alphabetical letter
   1. Poles labeled with A & H are the horizontal poles
   2. Connect A poles with H poles along with the corner pieces, resulting in 2 squares of poles
   3. Connect the B poles with the C poles, these are the vertical poles
   4. Ensure that the C poles are towards the bottom, and connect to the tops of the corner pieces
   5. Ensure that the B poles are facing upwards, then connect to the corner pieces
2. Move the tent frame to a horizontal position (on its side)
3. Unfold the tent cloth, unzip the door flap, and place the horizontal frame inside the tent 
4. Starting from the bottom, ensure that the frame corners are flush into the cloth’s corners
5. Slowly and evenly slide the cloth upwards and repeat the process with the top corners
6. Once corners are evenly inside the cloth, slowly and evenly zip up the door flap to confirm the cloth is tightly around the frame
7. Return the tent to a vertical position and place the poles labeled E and F in the top of the tent to assist with stability and light fixtures
8. Place the cloth floor inside the tent, shiny-side facing upwards

Ventilation

1. Unbox carbon filter and slide the cloth sock over the filter
2. Hang inline fan from the top poles that cross the center of the tent, making sure to keep the fan towards either side where the adjustable ventilation holes in the tent are
3. Use the provided metal clamps to secure one end of the ducting to the inline fan and push the ducting through the closest ventilation hole
4. Use a clamp to secure the opposite end of the ducting to the carbon filter unit
5. Secure the drawstring of the ventilation hole tightly around the ducting, ensuring that there are no light or air leaks
6. This setup will best utilize the space in the tent, but larger tents will allow for other configurations

Light

1. Unbox metal hangar kits, attached 4 small hooks to 4 holes on back side of the light
2. Connect with the included adjustable rope ratchet. Hang the light above the plants at appropriate height
3. Plug the power cord into the socket. Turn  on the VEG or BLOOM switch as needed